Linux version 2.6.32.12 (jrschulz@manowar) (gcc version 4.3.3 (GCC) ) #2 Sat May 1 14:25:09 CEST 2010 prom: fw_arg0=00000002, fw_arg1=80050028, fw_arg2=80050000, fw_arg3=00000001 MyLoader: sysp=00000000, boardp=00000000, parts=ace50014 bootconsole [early0] enabled CPU revision is: 00019374 (MIPS 24Kc) Atheros AR7161 rev 2, CPU:720.000 MHz, AHB:180.000 MHz, DDR:360.000 MHz Determined physical RAM map: memory: 08000000 @ 00000000 (usable) Initrd not found or empty - disabling initrd Zone PFN ranges: Normal 0x00000000 -> 0x00008000 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00008000 On node 0 totalpages: 32768 free_area_init_node: node 0, pgdat 802e59b0, node_mem_map 81000000 Normal zone: 256 pages used for memmap Normal zone: 0 pages reserved Normal zone: 32512 pages, LIFO batch:7 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512 Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=UBNT-RSPRO board=RouterStation PRO ethaddr=00.15.6d.c4.23.9d PID hash table entries: 512 (order: -1, 2048 bytes) Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes Writing ErrCtl register=00038002 Readback ErrCtl register=00038002 Memory: 126520k/131072k available (2053k kernel code, 4364k reserved, 532k data, 152k init, 0k highmem) SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Hierarchical RCU implementation. NR_IRQS:56 Calibrating delay loop... 478.41 BogoMIPS (lpj=2392064) Mount-cache hash table entries: 512 NET: Registered protocol family 16 MIPS: machine is Ubiquiti RouterStation Pro registering PCI controller with io_map_base unset bio: create slab at 0 pci 0000:00:00.0: reg 10 32bit mmio pref: [0x000000-0xfffffff] pci 0000:00:00.0: reg 14 io port: [0x00-0xff] pci 0000:00:00.0: supports D1 D2 pci 0000:00:00.0: PME# supported from D0 D1 D2 D3hot pci 0000:00:00.0: PME# disabled Switching to clocksource MIPS NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered NET: Registered protocol family 1 squashfs: version 4.0 (2009/01/31) Phillip Lougher Registering mini_fo version $Id$ JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. yaffs Apr 27 2010 22:18:29 Installing. msgmni has been set to 247 io scheduler noop registered io scheduler deadline registered (default) Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A console [ttyS0] enabled, bootconsole disabled Atheros AR71xx SPI Controller driver version 0.2.4 m25p80 spi0.0: mx25l12805d (16384 Kbytes) spi0.0: searching for MyLoader partition table at offset 0x10000 spi0.0: searching for MyLoader partition table at offset 0x20000 spi0.0: searching for MyLoader partition table at offset 0x30000 spi0.0: searching for MyLoader partition table at offset 0x40000 spi0.0: no MyLoader partition table found Searching for RedBoot partition table in spi0.0 at offset 0xfe0000 Searching for RedBoot partition table in spi0.0 at offset 0xff0000 5 RedBoot partitions found on MTD device spi0.0 Creating 5 MTD partitions on "spi0.0": 0x000000000000-0x000000030000 : "RedBoot" 0x000000030000-0x000000120000 : "kernel" 0x000000120000-0x000000ff0000 : "rootfs" mtd: partition "rootfs" set to be root filesystem mtd: partition "rootfs_data" created automatically, ofs=5D0000, len=A20000 0x0000005d0000-0x000000ff0000 : "rootfs_data" 0x000000ff0000-0x000000fff000 : "FIS directory" 0x000000fff000-0x000001000000 : "RedBoot config" ag71xx_mdio: probed eth0: Atheros AG71xx at 0xb9000000, irq 4 eth0: connected to PHY at ag71xx-mdio:04 [uid=004dd041, driver=Atheros AR8216/AR8316] eth1: Atheros AG71xx at 0xba000000, irq 5 eth1: AR8316 switch driver attached. eth1: connected to PHY at ag71xx-mdio:00 [uid=004dd041, driver=Atheros AR8216/AR8316] Atheros AR71xx hardware watchdog driver version 0.1.0 ar71xx-wdt: timeout=15 secs (max=23) TCP westwood registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller VFS: Mounted root (squashfs filesystem) readonly on device 31:2. Freeing unused kernel memory: 152k freed Please be patient, while OpenWrt loads ... gpio-buttons driver version 0.1.2 input: gpio-buttons as /devices/platform/gpio-buttons/input/input0 Button Hotplug driver version 0.4.0 Registered led device: ubnt:green:rf SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver ar71xx-ehci ar71xx-ehci: Atheros AR71xx built-in EHCI controller ar71xx-ehci ar71xx-ehci: new USB bus registered, assigned bus number 1 ar71xx-ehci ar71xx-ehci: irq 3, io mem 0x1b000000 ar71xx-ehci ar71xx-ehci: USB 2.0 started, EHCI 1.00 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ar71xx-ohci ar71xx-ohci: Atheros AR71xx built-in OHCI controller ar71xx-ohci ar71xx-ohci: new USB bus registered, assigned bus number 2 ar71xx-ohci ar71xx-ohci: irq 14, io mem 0x1c000000 usb usb2: configuration #1 chosen from 1 choice hub 2-0:1.0: USB hub found hub 2-0:1.0: 2 ports detected Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. mini_fo: using base directory: / mini_fo: using storage directory: /overlay NET: Registered protocol family 10 lo: Disabled Privacy Extensions ADDRCONF(NETDEV_UP): eth0: link is not ready ADDRCONF(NETDEV_UP): eth1: link is not ready device eth1 entered promiscuous mode lib80211: common routines for IEEE802.11 drivers lib80211_crypt: registered algorithm 'NULL' lib80211_crypt: registered algorithm 'WEP' lib80211_crypt: registered algorithm 'CCMP' lib80211_crypt: registered algorithm 'TKIP' Generic kernel compatibility enabled based on linux-next next-20100113 cfg80211: Calling CRDA to update world regulatory domain ar71xx: pll_reg 0xb8050014: 0x110000 eth1: link up (1000Mbps/Full duplex) br-lan: port 1(eth1) entering forwarding state ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready cfg80211: World regulatory domain updated: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) Slow work thread pool: Starting up Slow work thread pool: Ready RPC: Registered udp transport module. RPC: Registered tcp transport module. RPC: Registered tcp NFSv4.1 backchannel transport module. loop: module loaded PPP generic driver version 2.4.2 Installing knfsd (copyright (C) 1996 okir@monad.swb.de). ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 24 nf_conntrack version 0.5.0 (1982 buckets, 7928 max) CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or sysctl net.netfilter.nf_conntrack_acct=1 to enable it. IMQ driver loaded successfully. Hooking IMQ before NAT on PREROUTING. Hooking IMQ after NAT on POSTROUTING. xt_time: kernel timezone is -0000 nf_conntrack_rtsp v0.6.21 loading nf_nat_rtsp v0.6.21 loading ip6_tables: (C) 2000-2006 Netfilter Core Team libipw: 802.11 data/management/control stack, git-1.1.13 libipw: Copyright (C) 2004-2005 Intel Corporation ipw2100: Intel(R) PRO/Wireless 2100 Network Driver, git-1.2.2 ipw2100: Copyright(c) 2003-2006 Intel Corporation usbcore: registered new interface driver ums-alauda usbcore: registered new interface driver ums-cypress usbcore: registered new interface driver ums-datafab usbcore: registered new interface driver ums-freecom usbcore: registered new interface driver ums-isd200 usbcore: registered new interface driver ums-jumpshot usbcore: registered new interface driver ums-karma usbcore: registered new interface driver ums-sddr09 usbcore: registered new interface driver ums-sddr55 usbcore: registered new interface driver ums-usbat usbcore: registered new interface driver usbhid usbhid: v2.6:USB HID core driver br-lan: no IPv6 routers present eth1: no IPv6 routers present ar71xx-wdt: enabling watchdog timer device eth1 left promiscuous mode br-lan: port 1(eth1) entering disabled state device eth1 entered promiscuous mode br-lan: port 1(eth1) entering forwarding state yaffs: dev is 32505856 name is "mtdblock0" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.0, "mtdblock0" yaffs: MTD device is not NAND it's type 3 yaffs: dev is 32505856 name is "mtdblock0" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.0, "mtdblock0" yaffs: MTD device is not NAND it's type 3 yaffs: dev is 32505857 name is "mtdblock1" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.1, "mtdblock1" yaffs: MTD device is not NAND it's type 3 yaffs: dev is 32505857 name is "mtdblock1" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.1, "mtdblock1" yaffs: MTD device is not NAND it's type 3 yaffs: dev is 32505860 name is "mtdblock4" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.4, "mtdblock4" yaffs: MTD device is not NAND it's type 3 yaffs: dev is 32505860 name is "mtdblock4" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.4, "mtdblock4" yaffs: MTD device is not NAND it's type 3 yaffs: dev is 32505861 name is "mtdblock5" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.5, "mtdblock5" yaffs: MTD device is not NAND it's type 3 yaffs: dev is 32505861 name is "mtdblock5" yaffs: passed flags "" yaffs: Attempting MTD mount on 31.5, "mtdblock5" yaffs: MTD device is not NAND it's type 3